HVAC in Salem, NH
Service One Heating and Cooling repairs and installs heating and cooling systems throughout Salem, from North Salem and Millville to the neighborhoods around Canobie Lake and the Route 28 and Route 38 corridors.
- Service area
- Salem, Rockingham County
- Natural gas
- Available through Unitil
- Heating fuel
- 48.2% oil, 14.7% gas
- Heating permits
- Inspectional Services Division
Heating and cooling service across Salem
Salem was incorporated in 1750 and runs south to the Massachusetts line. Its median home dates to 1977, and only Manchester and Nashua have older housing in our service area, so a lot of Salem calls are end-of-life furnaces, boilers and outdoor AC units paired with ductwork that needs rebalancing.
Furnace repair, AC repair and heat pump installation in Salem
Furnace repair and replacement in Salem
Salem homes run oil, gas and propane in roughly that order. We repair and replace furnaces and boilers on all three fuels, including oil-to-gas conversions where Unitil gas reaches the home.
Learn moreAC repair and installation in Salem
Much of Salem's housing dates from the 1970s, when central air was often added later. We repair aging systems and size replacements with a room-by-room load calculation rather than the old unit's label.
Learn moreHeat pump installation in Salem
For the 69% of Salem homes on oil or propane, a cold-climate heat pump can replace or back up the existing system. We are an NHSaves participating contractor and handle the rebate paperwork.
Learn moreWater heater installation in Salem
We replace failed tanks and install tankless, indirect and heat pump water heaters, matched to the fuel your home already uses.
Learn moreHeating and cooling in Salem
Salem has natural gas through Unitil, but 48.2% of homes still heat with oil, so oil service, gas conversions and heat pumps all come up here.
What Salem actually heats with
Across roughly 13,737 housing units, 14.7% of Salem homes heat with natural gas, 48.2% with fuel oil, 20.8% with propane, 11.7% with electricity and 1.9% with wood. That puts 69% of the town on delivered fuel. Statewide the split is 21.4% gas, 39.5% oil and 19.2% propane. New Hampshire ranks second in the nation for home heating oil use per capita, and oil and propane together heat 58.7% of homes statewide.
Utilities serving Salem
Check your electric bill to confirm which utility serves your address. Natural gas is available in much of town through Unitil. Which utility appears on your bill matters, because NHSaves rebates for heat pumps and other equipment are administered by the utilities themselves. Check the provider printed on your own bill before assuming eligibility: then see our current NH rebate guide.
How HVAC permits work in Salem
Permitting for Salem runs through Salem Inspectional Services Division. Salem's Inspectional Services Division has sat inside the Fire Department since 2016 and staffs a dedicated Plumbing/Gas/Mechanical Inspector. A permit is required for a new heating plant, including a straight replacement. We pull the permits and meet the inspector: you don't chase paperwork.
The Salem housing stock
The median Salem home was built in 1977, and 75.6% of occupied homes are owner-occupied (census estimates across roughly 13,737 housing units). Homes from that era are typically on their second or third heating system, so we see a lot of end-of-life equipment paired with ductwork that needs rebalancing.
Population: 30,964 (census estimate).
Sources: Heating-fuel, housing and population figures are US Census Bureau American Community Survey 2020 to 2024 five-year estimates (tables B01003, B25001, B25003, B25035, B25040, B25077). Utility territory from the NH Department of Energy and the utilities' own service-area maps. Permit details from the town's building department. Census estimates are five-year averages, not current counts.
All HVAC services in Salem
HVAC guides for Salem homeowners
The 30%-of-replacement-cost rule is a good starting point, but only if you apply it honestly. Here's how to weigh age, repair history, heat exchanger safety, and current fuel costs before deciding.
Using current EIA fuel prices, here's a full worked example of switching an 800-gallon-a-year oil home to a heat pump, plus where the breakeven sits and when the switch isn't worth it.
Before you call for emergency heat service, work through this order: thermostat, power switch, condensate pump, filter, and the oil/gas-specific checks: then know exactly when to stop and call.
Nearby towns we serve
What our customers say
Verified Google reviews from customers across southern New Hampshire.
"Service One did a great job getting my unit up and running. Quick response. Replaced both the furnace and condenser. Highly recommend them."
"Dana called me this morning and was able to squeeze me in to have Brian look at my central air motor. Brian was on time and was very professional and knowledgeable. Cannot thank Service One enough for saving me from today's 100° day. I will recommend Service One to all my friends."
"Very professional."
Frequently asked
Salem's Inspectional Services Division, which has been part of the Fire Department since 2016 and has a dedicated Plumbing, Gas and Mechanical Inspector. A permit is required for a new heating plant, including a straight replacement. We pull it as part of the job.
If Unitil gas service reaches your street, often yes. Unitil can confirm availability at your address. We also quote a cold-climate heat pump on the same visit so you can compare both options.
Yes. Salem homes use all three, and we repair, tune up and replace equipment on each fuel. Estimates on replacements are free.
Same-day service on most routine calls, and typically 2 to 4 hours for true emergencies. Times are typical, not guaranteed. Office hours are Monday to Friday, 7am to 5pm. Call (603) 634-9717.
HVAC help in Salem?
Call now or request a free estimate: we typically respond same-day.
