Skip to main content
NHSaves participating contractor

NH Heat Pump Rebate 2026: The Real Numbers

NHSaves rebates plus the New England Heat Pump Accelerator can meaningfully cut the cost of a heat pump in southern New Hampshire, but the "$2,000 per ton" number everyone quotes usually isn't your number. We'll show you the math that actually applies to your home.

The $2,000 per ton number is real, and it probably isn't yours

Search "NH heat pump rebate" and nearly every result leads with "$2,000 per ton." It's not made up: it's a genuine 2026 NHSaves rate. But it applies to exactly one situation: a ductless heat pump replacing electric resistance heat (electric baseboard or an electric furnace), installed between 3/23/2026 and 12/31/2026, with pre-verification completed first.

Most homes in Hampstead, Derry, Salem, and the rest of southern NH heat with oil or propane. For those homes, the applicable ducted-system rate is $250 per ton: a real number, but a very different one. Here's the honest comparison, side by side.

Typical southern NH home
4-ton ducted heat pump replacing an oil furnace
4 × $250 = $1,000

NHSaves rebate, plus the New England Heat Pump Accelerator discount on top (up to $1,300 for 2 outdoor units).

The viral number
4-ton ductless system replacing electric baseboard, installed after 3/23/26
4 × $2,000 = $8,000

Requires pre-verification. Only applies when the home was previously heated with electric resistance. Plus the Accelerator discount.

The New England Heat Pump Accelerator: almost nobody mentions this

Separate from NHSaves, the New England Heat Pump Accelerator provides an instant point-of-sale discount of $650 per outdoor heat pump unit, up to a maximum of 2 units per dwelling. It flows from the manufacturer through the distributor to the installing contractor and shows up as a line-item discount right on your invoice: no separate rebate form to mail in.

It stacks with your NHSaves rebate. Most NH contractors either don't participate or don't bother explaining it to customers. Service One applies it automatically whenever the installed equipment qualifies, so it's baked into your quoted price rather than something you have to chase down later.

NHSaves 2026 rebate table (Eversource, Liberty, Unitil)

Residential electric customers of Eversource, Liberty, or Unitil. Equipment must be on the NHSaves Heat Pump Qualified Product List.
EquipmentRebateNotes
Air-source heat pump, ducted$250 per tonAny fuel replaced · limit 5 tons/account
Air-source heat pump, ductless: replacing electric resistance$1,250/ton (1/1–3/22/26) then $2,000/ton (3/23–12/31/26)Pre-verification required
Central air conditioner (ENERGY STAR)$70 per tonN/A
Wi-Fi thermostat$85 per unitMust install with qualifying heat pump, one per zone
Heat pump water heater$900 (up to 85 gal)ENERGY STAR, ≥3.30 UEF integrated / ≥2.80 UEF split
Weatherization (Home Energy Performance)Up to $6,000Applied to improvement costs

Swipe to see the full table

New Hampshire Electric Co-op members

NH Electric Co-op runs its own version of the program for member-customers, with the same structure:

EquipmentRebate
Ducted heat pump$250 per ton
Ductless, replacing electric resistance$2,000 per ton
Central AC (ENERGY STAR)$70 per ton
Wi-Fi thermostat$85 per unit

Swipe to see the full table

Estimate your rebate

Answer a few questions about your home to get a plain-math estimate. This tool is for planning only: your exact number depends on the specific equipment and is confirmed at your free in-home estimate.

Estimate your rebate

Answer four quick questions. This is a plain-math estimate based on the published 2026 program rules, not a quote, and not a substitute for pre-verification or the qualified product list.

What do you heat with today?
Ducted or ductless?
1 ton6 tons
Are you a residential electric customer of a participating utility?

Answer all four questions above to see your estimate.

This is an estimate only, not a quote or a guarantee of eligibility. Final rebate amounts depend on the specific equipment being on the NHSaves Heat Pump Qualified Product List, correct pre-verification where required, install dates between 1/1/2026–12/30/2026, and forms postmarked by 1/30/2027. Service One confirms exact numbers at your free in-home estimate.

How the paperwork actually works

  1. 1

    Free in-home estimate

    We size the system with a load calculation and confirm the exact model numbers, AHRI ratings, and installed price: the details a rebate application needs.

  2. 2

    Check the qualified product list

    We verify the specific equipment against the current NHSaves Heat Pump Qualified Product List before you sign anything, and flag if pre-verification is required for a ductless-replacing-electric-resistance install.

  3. 3

    Install between 1/1/2026 and 12/30/2026

    Install date determines the rebate year and, for ductless-replacing-electric-resistance systems, which per-ton rate applies.

  4. 4

    Accelerator discount applied automatically

    If the equipment qualifies, the $650-per-outdoor-unit New England Heat Pump Accelerator discount is applied at the distributor level and shows up as a line item on your invoice: no extra form from you.

  5. 5

    Service One files the NHSaves paperwork

    As a participating contractor, we submit the invoice, AHRI certificate, and rebate form. Forms must be postmarked by 1/30/2027; we file well ahead of that.

We file the paperwork

Service One is an NHSaves-participating contractor. We check the qualified product list, handle pre-verification when it applies, and submit your rebate forms: you just cash the check.

Get your free rebate-ready estimate

Frequently asked

Get your real rebate number, not the internet's

Free in-home estimate. NHSaves and Accelerator paperwork handled for you.